Page 1 of 1

Help please!!!

Posted: Mon Jul 15, 2013 12:42 pm
by GRAUWULF
Having just decided to get back into reenacting after a horrendous year I thought a new bit of kit would help. I,ve aquired a ural m63 correctly fitted out as an R71 with sidecar, mg etc etc. Once going they are great but can be a real bitch to start from cold. It doesnt help with the instructions all in german especially on the choke lever. CAN ANYONE advise on a best method of prestar and starting to avoid frustrated scraped shins etc.
Cheers
Chris

Re: Help please!!!

Posted: Mon Jul 15, 2013 3:18 pm
by funker50
how do chris, glad to see things are looking up for yeeee. You could always do what the boche did n warm the MT up with somekind of heater ;-) don't wanna swap for a KDF wagen project do ya ;-).......
I'm sure someone with a similar set up will be on here shortly or failing that after that show daaaaan saaaaarf...

mat

Re: Help please!!!

Posted: Mon Jul 15, 2013 5:38 pm
by GRAUWULF
Cheers Mat good to here from ya again buddy!!

Re: Help please!!!

Posted: Mon Jul 15, 2013 7:46 pm
by peterwulfhund
squirt some Bradex Easy Start down the air intake ..circa £5 a spray tin, lasts ages ! ( get it from little olde car spares type shops. ) :wink:

Re: Help please!!!

Posted: Tue Jul 23, 2013 9:54 pm
by sparky
Noooooo don't easy start it! One they get a sniff they will never start without it again

Re: Help please!!!

Posted: Wed Jul 24, 2013 7:25 am
by jimmyvonk
sparky wrote:Noooooo don't easy start it! One they get a sniff they will never start without it again
THIS IS GOOD ADVICE - Easystart is addictive. Fix the problem don't mask it.

First thing with these Ruski mong combo's is to find out what you actually have - what engine - does it have the correct carbs on it, is everything set correctly for the engine you have?

They are not all the same, and lots of people get in a fix by putting together bags of bits and expecting it to run straight off the box.
It is not, and never will be a German bike... you need the manual for a russian bike and suitable russian tools (lump hammer, crow bar, beer cans, cornflake packet, vodka etc) :lol:

Bung some fresh fuel in it, set timing and clean and gap the plugs and points. It should give you a starting point.

Re: Help please!!!

Posted: Fri Aug 09, 2013 12:08 pm
by GRAUWULF
thanks for all the advice guys think I may have got it cracked so should be at Vic with it hopefully!!!

Re: Help please!!!

Posted: Mon Aug 12, 2013 8:09 pm
by 352nd
Hi Chris

Some of our boys have got urals currently in restoration. We've got a section on our forum about Krads and all things motorbike. You might find some advice on there. http://www.gdrecon.co.uk/forum/viewforum.php?f=43

See you at the Victory Show mate.
Martin